Aircraft Check Out & Maintenance Guideline
The following items should be checked regularly,
at least before the first flight every flight date. It is recommended that
most items be checked after each flight date, at home, so there will be no
sunrises at the field next time out. Do not fly aircraft that does not pass
all of these criteria.
- Propeller & spinner secure - propeller properly balanced &
undamaged - Do not use a damaged propeller.
- Engine bolts secure to mount - Mount secure to firewall.
- Fuel tank secure, preferably in foam rubber
- Tank clunk free.
- Receiver, battery, all servos secure - Receiver in rubber - Wires
clear of all moving control horns & pushrods - Antenna clear of servos.
- Minimal free play in servo horns & pushrods - Control horns secure
- Clevis' secure with safety retainers.
- All control surface hinges secure (especially ARFs)
with minimal gap - Free movement (no binds) all control surfaces - Rudder,
- Throttle travel, idle to full - Shut off travel OK - No servo bind
at full throttle (nothing drains a battery more than a servo bind.)
- Nose wheel straight, at least sensitive position - Roll test on pavement
- Aileron servo connected - Retainer or baffle to keep aileron wire
from entangling in aileron rods.
- Rubber band quantity & installation - Do not use old or used rubber
bands. Recommended installation: 2 crossed, 6 straight (3 each side), 4
- Balance empty (no fuel) - Do not fly a tail heavy aircraft. Remember,
a nose heavy plane flies sluggish; a tail heavy plane usually only flies
- AMA number & proper identification - Name and address inside
- Receiver battery voltage - Do not operate below 4.9 volts.
here to go back